mega2

mega2-2

  • MOTOR: 87.02 bore with Mahle piston and new ring .0025 cylinder clearance. All new crank bearings and main trans bearings, new decomp valve, new seals and gaskets, new primary chain, gears in trans have been blueprinted for smoothness. Cylinder has had minor porting job for top end improvement. Clutch is the newer type OEM Maico. Equipped with DEP pipe and silencer and new air filter.
  • FRAME:  gusseted in rear sub frame area for stiffness, original paint, lower frame is not dented or flat like most are. New swingarm bearings and bushes. Equipped with Falcon wide body shocks. Swing arm is not bent or twisted, new wide footpegs installed.
  • FRONT FORKS: chrome is very nice, new fork bushings, seals and wipers installed.
  • PLASTIC: the fenders and side panel were installed by the previous owner and are new, the tank is OEM and is in very nice condition.
  • SEAT: the cover and foam are new, there is a slight crack in the seat pan but very minor.
  • BARS and CONTROLS: bars are new controls are OEM Magura in very good condition, new Venhill cables are installed along with new Magura kill switch, grips are new
  • WHEELS: are new Sun Rims with HD stainless steel spokes. New HD Bridgestone tubes with new Bridgestone tires and new rim locks, new wheel bearings front and back, new brakes front and rear.
  • SPROCKETS: are new Talons, 13 on the front and 56 on rear along with new sprocket nuts and bolts.
  • CHAIN: is new D.I.D
  • CARBURETOR: new jets and slide along with new gaskets and "O" rings
  • GENERAL DESCRIPTION: This is a good as it gets, its what I refer to as "race ready". there is nothing required by the rider but gas. It wont last and is priced to sell at $6500 or best offer, we can assist in shipping.

Orders: 1-844-477-5746 Tech Support: (250) 477-5746 E-mail: maicomaster@shaw.ca